TM-6900_Super_Go_Back_Software

[^^COMPASS^^]

TM-6900 Super {Go Back sofware }


1st November 2009

Use this software by rs232 only when front panel displaying Technomate

================================================== ====




FORCED DOWNLOAD INSTRUCTIONS

You will need to have your receiver connected to your PC via a Null modem cable!


Just make sure you use TM-6900 Super {Go Back sofware }
and also make sure you are using darkman loader v1.87 and not an older loader


turn the receiver off at the rear mains switch and re-load the TM-6900 Super {Go Back sofware },

and when the darkman v1.87 loader asks connect to receiver turn it back on at the rear

turning the receiver on at the rear will force the download and clear the problem caused by any incomplete or faulty patches

after it has completed , reboot the box by turning it off and on again at the rear mains switch ( power cycle the box )

the box should boot and work normally

sometimes you may have to remove the lnb cable when the box is off , just to stop it looking for channels , reconnect this after the box has been restored but turn it off beforehand

now switch it back on and test

Regards...